The name may not be familiar as I think it is the dealers name on the label. In my last post I said I had 'dumped' my Mag 8 and replaced it with another. I was wondering what cards could work with the Mag 8 18amp. I will post the results of my test this week-en, unless someone confirms the whole thing before that! I hope this is going to help people stuck with this piece of electronics.ītw, the turnigy programming card from Hobbyking works on the mag 8 (18a) just fine, except ignore the helicopter governer on item 8 (it is the exit entry) Thanks for that info about the card. I don't have my MAG-8 version H esc right now, so I can't test all this stuff. 3- BEFORE hearing the little jingle that tells you that you are in prog mode, you must get you throttle stick fully down. From what I understand, it's a bit like entering in programming mode, but you have to act quicker.ġ- Power on full throttle. 2.amplifier and connect the battery to wait two seconds and two short beep sound, high storage position full amp.ģ.rethrow throttle stick to the beep鳴TTARA above (bottom) and one short beep and wait for a second time Attention, memory amp slow position. 1.high point of professional full-throttle stick (top). Here's how to setup the throttle range according to Google translate: If you use a professional first point of the amplifier must be stored in the amplifier the throttle wide range of professional post. Tower Pro MAG 8 ESC programming? Did the Hexrtonix program work with the TowerPro? I followed the Tower Pro instructions for the 18amp model. Customers Who Bought This Item Also Bought. Program the Pentium ESC from HobbyWing using this program card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |